How to fix error e08 on hoover washing machine

How to fix error e08 on hoover washing machine

How to Fix Error E08 on a Hoover Washing Machine

If your Hoover washing machine displays error code E08, it means there’s a problem with the motor or the motor speed sensor. This issue often results in the machine not spinning and clothes coming out wet. Here’s how to diagnose and fix the problem safely.

What Causes Error E08?

  • Faulty motor or worn motor carbon brushes.
  • Faulty motor speed sensor.
  • Overloading the drum with too many clothes.
  • Wiring issues or electrical faults in the motor circuit.

Step-by-Step Fix

1. Reduce the Load

If you’ve overloaded the drum, remove some clothes and try running the machine again. Overloading can trigger the E08 error.

2. Safety First

Always unplug the washing machine from the mains before starting any repair work.

3. Access the Motor

  • Remove the back panel of the washing machine using a 7mm nut runner or screwdriver.
  • Locate the motor and disconnect the electrical connections and earth wire.

4. Remove the Belt and Motor

  • Take off the drive belt by turning and pulling it from the motor spindle and pulley wheel.
  • Unscrew the two bolts securing the motor (usually 10mm bolts), then carefully pull the motor free.

5. Inspect and Replace Carbon Brushes

  • Check the motor’s carbon brushes. If they are worn down, replace them with new ones—a common cause of E08.
  • Remove the wires and screws holding the brushes, replace with new brushes, and reattach.

6. Reassemble and Test

  • Reinstall the motor and belt, reconnect wires, and secure the back panel.
  • Plug the machine back in, reconnect water and drain hoses, and run a test cycle.

Video Guides

  • Hoover Washing Machine E08 Error Code - How to Fix!
  • Error E08 on Hoover Washing Machine | How to Fix

Additional Tips

  • If replacing the carbon brushes doesn’t resolve the issue, the motor or speed sensor may need replacing.
  • Persistent E08 errors could indicate a deeper electrical fault—consult a qualified appliance technician if unsure.

Summary Table: E08 Error Fixes

Cause Solution
Overloaded drum Remove excess laundry, restart machine
Worn carbon brushes Replace carbon brushes
Faulty motor/sensor Replace motor or speed sensor
Wiring/electrical issue Inspect and repair wiring, seek technician

By following these steps, most users can resolve the E08 error and restore their Hoover washing machine to working order. Always prioritize safety and consult a professional if you’re not confident with electrical repairs.

Related Articles :

Back to blog